FAQ
  • Why is my Lightburn "busy" and the machine doesn't move?
  • The engraving machine cannot connect to LaserGRBL
  • The engraving is not straight
  • When drawing a straight line, it turns into a curved line.
  • How to improve the quality of engraving?
  • Why the image is not clear?
  • How to increase the movement speed of the preview frame?
  • Can I engraveon curved object？
  • Why the image I engraved is mirrored or backwards?Why does the laser move in the opposite direction?
  • Why is my laser exceeds range for engraving?/Why does my laser rattle when moving to the border?
  • Why is my engraved images ghosting? /Why does it appear double lines?
  • Why can't my Lightburn software find /connect to the laser?
  • Why is my software running properly but the laser stops?
  • Why is the moving distance of the laser different from the software?
  • Why is my lasermoving so slowly?
  • Which version of lightburn software should be buy?
  • Why do I change the speed but the movement speed stays the same?
  • How to solve Over-burned edges?
  • How to change the engraving size?
  • How far should the laser be from the engraved object?
  • Why the corners of the image l engraved are burnt or too dark?
  • Why is the back of the plank I cut badly charred?
  • Why is the laser power getting weaker?
Powered by GitBook
On this page

Why is my software running properly but the laser stops?

The cable on the laser is disconnected or the laser is not homing before engraving, causing the laser exceed the working area and be forced to stop. Please reconnect the cable and home the laser.

PreviousWhy can't my Lightburn software find /connect to the laser?NextWhy is the moving distance of the laser different from the software?

Last updated 11 months ago