CutlabX

CutlabX

Instructions of CutLabX App

Download

Scan the QR code below or search in the app store or goole play to download the CutLabX app to your phone. Important note: For mobile APP, it is recommended to use Cutlabx software to connect to the machine. If you have downloaded MKSlaser and the connection is unstable, please switch to Cutlabx to operate.

Connect to the machine

a) Turn on the power of the machine and turn it on.

b)Turn on the WLAN on the mobile phone, find the WIFI signal named WOXCKER_L8 MAX, and the password is 12345678.

c) After the WIFI connection is successful, open CutLabX, click the link mark in the upper right corner-, enter 192.168.0.1 in the IP address, and click Connect to complete the connection.

Introduction of the interface

Engraving setting

Click "Start your Creation" on the home page, and click "Next" after importing pictures or drawing text.

Then select the engraving style (Monochrome,Jitter,Contour,Grayscale). You can adjust parameters according to the effect of the preview window.

Note:Please make sure that the memory card has been inserted into the controller, the mobile phone and controller have been connected to the same WiFi, and the CutLabX App has entered the correct IP address.

Set the File Name, Engraving Size, Work Speed and Laser Power. Click the “Engrave” icon in the lower right corner to start uploading files.

Note: If the upload fails, please check whether the TF card is inserted into the machine. If not, please insert it.

After the file is uploaded successfully, engraving will start automatically. On the engraving page, the position and engraving progress are displayed.

Note:The speed of uploading images affected by the memory of images. It will take longer time to upload images with higher pixels and larger sizes, ultra large images may fail to upload.